Auto Part Mould Manufacturers

5) Mark the cavity height dimension (not required, as needed) and the overall size of the mold. 5) Requirements for test and inspection. Usually the process picture is on the mold assembly drawing. 7) Program all the part numbers in order and fill out the schedule. 4) Anti-oxidation treatment, mold number, lettering, marking, oil seal, storage and other requirements. 4) Outline structure and position of all connectors, positioning and guides. 6) Auxiliary tools (removing tools, correction tools, etc.. under the process diagram. 2) Requirements for the mold assembly process. 8) Mark technical requirements and instructions for use.

The drawing starts with the cavity, and the main view is drawn at the same Auto Part Mould Manufacturers time as the other views. 3) Parting surface and parting mode. (2) Technical requirements of the mold assembly drawing: 1) Performance requirements for certain systems of the mold. (1) The assembly drawing of the mold shall include the following contents: 1) Structure of the mold forming part 2) Structure of the pouring system and the exhaust system. Drawing the assembly structure drawing The total assembly drawing is drawn in a ratio of 1:1. Before drawing the master assembly drawing, the process drawing should be drawn and conformed to the requirements of the parts drawing and process data.

The size guaranteed by the next process shall be marked with the words 'Process Size' in the figure.05 mm, and the size determined by the assembly and the requirement for the size are pointed out. For example, the fitting gap of the bonding surface of the parting surface after the mold is assembled should be no more than the parallelism requirement of the upper and lower sides of the mold of 0. It is best to mark the part number, name, material, material shrinkage rate, drawing ratio, etc.Steps for the mold factory to draw the assembly structure diagram

It is required to draw according to the national drawing standard, but it also requires the combination of factory standards and factory customary methods not specified by the state.). If, after the molding, no other machining is performed except for the repair of the burrs, the process diagram is exactly the same as the workpiece drawing. For example, the assembly requirements for the ejector system and the slider core structure. 3) Mold use, assembly and disassembly methods

Megosztás a facebookon